Welcome, Guest. Please login or register.
Did you miss your activation email?
November 19, 2018, 04:15:45 PM
Home Help Search Login Register

+  DIY DataRecovery.nl Support forum
|-+  Support
| |-+  iRecover (Moderators: Tom, Joep)
| | |-+  Autosave Error After Successful Scan
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Autosave Error After Successful Scan  (Read 2314 times)

Posts: 1

« on: December 30, 2016, 12:49:00 AM »

Happy Holidays!
Running the iRecover trial on Windows 10 'run as' Administrator
Iomega ix4-200d
3 of 4 RAID 5 SATA drives attached locally and scanned fine. iRecover understands the existing Linux native software RAID, sectors, bytes, stripe etc.
End of scan result is "There was an error while autosaving the scan result.  Unknown storage object type."
C:\iRecover\AUTOSAVE\*.recovery file is created but remains at 0 bytes.
Once I click through the error, I can see an Xfs top folder in the left window pane but the program hangs with the 'Saving' dialogue box on top.

Any pre-sales guidance greatly appreciated!  Thank you.
Developer and Support Tech
Posts: 1473

« Reply #1 on: December 30, 2016, 09:07:26 AM »


- Try with autosave disabled (advanced config > general tab > untick 'enable autosave'.

- Or: try this version instead (if not using this already): http://www.diydatarecovery.nl/downloads/Demo/iRecover.zip


Kind regards,
Joep - My blog @: www.disktuna.com - Try my JPEG Repair Tool: https://www.youtube.com/watch?v=WIUq03Deyy0
Pages: [1] Go Up Print 
« previous next »
Jump to:  

Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!